Hey all, The little A12 is coming out tomorrow so I can spray the bay, I want a fairly good job, but i don't want to remove wiring harness, brake booster, or brake lines, everything else will be out.

Also, looking at painting the engine and parts when it is out, thinking about using a pedestal wire wheel on things like, alternator regulator, wiper motor and timing cover, then just doing a clear coat over the top so it doesn't rust/corrode, painting block and rocker cover as close as i can to stock, also the air filter.

Not sure if i should remove manifolds to paint, or leave them on and mask/news paper.

Has anyone ever done something similar to this before and have tips/tricks ideas, that they would like to share?

Any positive input is greatly appreciated.

Thanks, Zak

Attach file:

---

  IMG_0852.JPG (179.23 KB)