hey people im having some dramas with my rodeo

im half way through an rb30t engine conversion and the motor is mounted turbo is on and its wired up

the thing is ,when i plug the NA computer in ,with a good airflow meter it runs idles and revs fine ,and sounds mint

but when i plug the turbo computer in it wont run ,just fires then stops when i crank it ,if i unplug the AFM it will start fine and idle sweet ,and i can rev it to roughly 3000rpm before it hits limiter (limp home mode)

if i start it then plug the afm in it just stalls!

whats this sound like? the screw on the side of the afm hasnt been adjusted but could that be the problem?

problem occurs no matter where i place the dizzy

anyone got an idea whats causing this ?

ill put some pics up if anyones keen to see a VL turbo motor shoe horned into a rodeo

cheers!