Hi guys, this plenum is up on Ebay and Gumtree, just posting here in case you missed it..

For Sale: Nissan CA18DET "Race Series" Custom Inlet Plenum Setup to suit Datsun 1200/120Y

Comes with:
*Custom Plenum Creations Inlet Plenum NEW
<Internal bell mouths, CNC Head Flange, CNC Thermostat housing, Australian made>
*Dual Feed Billet Fuel Rail NEW
*Plazmaman 66mm Throttle Body NEW
*Plazmaman "Plazmaclamp" and mating flange for throttle body (No leak seal between piping and throttle body) NEW
*Plazmaman universal TPS switch (not pictured but comes with) NEW

Reason for selling: No longer needed, will be running a 4 port head instead of 8 port.

Condition: Brand New, test fitted the plenum to an engine only, a few little marks from transport (as pictured), these aren't deep, just scratches that will come out by simply using scotchbrite, or even just a light clean/polish. Manifold is sold in "raw" finish, ready for polishing, painting or powder coating.

All of this stuff cost me $2400, unfortunately changing the head design means its no longer good for my setup. The picture of the plenum fitted is a CA18DET in a 120Y Wagon, with large 240K brake booster (most guys run the small can 180B booster, so no fitment problems there). The "Race Series" plenum eliminates the 2 piece factory manifold that comes on the CA18DET, this means the piece with the butterflies is eliminated. The CNC flange for the thermostat suits a stock CA18DET thermostat.

Any other questions, gimme a call on 0401 535 four three three.
or email: mick120y AT gmail.com<br/><br/>

$1700.00

Attach file:

---

  PLENUM_1.JPG (82.19 KB)