Browsing this Thread:
1 Anonymous Users
|
|
flywheel weights |
|
Home away from home  
Joined:
2007/9/4 15:03
From Fremantle, West Australia
Group:
Registered Users
|
just swapped engines in my WHB310 While doing this I discovered that the A14/15 factory flywheel is about 5mm thicker than the A12 flywheel fitted to the new motor. The thinner A12 flywheel resulted in the release bearing being too far away from the clutch. Problem solved by retaining the A14 thick flywheel. While I had both flywheels off , I weighed them and found the A14 thick flywheel was only 500g heavier than the A12 flywheel.
My question is : on a stock motor, is there any advantage or disadvantage in using the slightly lighter flywheel?
Posted on: 2015/6/8 17:04
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
