Hello guys,

As some of you are aware I'm currently doing a engine swap and a hole other mods to my Datto.

Lately I have encounter some issues with parts that I have order. Need some advice from the expert.

Before anything let me clarify my intentions and parts to be use. The car is for streett use with drag racing intent. Will be using 15x4 front wheels with 5 x 4.5 bolt pattern.

What I'm after is lower the car at least probably 3 inches and do a custom brake set up!

So here we go with h the issues that I need d help.

I order a set of MadDat lower control arm and Techno Toy Tunning coil over kit, thinks ny will be a straight tit. To my surprise they are made for the 50mm and unes and the bigger balljoint. Because of this. I went and bought a set of 310 struts, so far so good until I try to fit a set of struts cartrige originally bought for the 1200 struts.

I have read the Wiki and probably not understand all that much info 😬. My question is which insert will fit the 310 struts and are smaller so I can do the coilover set up?

Here is my second issue, want to install a set of Wildwood set up to them by having some issues getting the Timken parts number for both ballbearing front inner and outer. Reason is... I need to find a way to match the ID of the 310 with the OD of the Wilwood hub. Which are made for the Mustang 2 set up know as Pinto also



Thanks in advance

Jose