I have an A15 with SSS manifold and twin 40mm webbers. Does anyone know the prefered cam angles for the A15 to suit this intake??

Jak, What are you plans for this motor, road/race/rally, I have the cam specs that i use in a similar size motor which is in the rally car, what size chokes are in the webers? I use to have 34mm in my 40's before i went to 45's with 38mm chokes, it does make a difference to your cam selection and intentions for your motor.

I'm putting it into a 1200 ute, wich will just be for personal use. I'm assuming there 34mm chokes. I want it tourquey lower down in the revs rather than for higher revs.

it's probably best if i give you the name of the company who ground my cam. they are Sure Cam at Stafford, ph: 3352 4777, they will spend some time talking to you about your application and your motor, i highly recommend them, i'm thinking about getting a different profile cam for my motor, the cam regrind should cost about $120 with a supplied cam, hope this is of some help to you.

Hi Jak,I have a cam in my A 15 that is very torquey low down an mid range.I have a profile for reproducing this cam.If you are interested I could take you for a ride and show you what it feels like.I also have a couple of Thighe Cams camshafts gathering dust under the house,maybe one of these would interest you,i dont want a lot for them.If interested,give me a ring on 33513655.
Jim.

Thankyou for your help. I've found someone who will grind my cam to the specifications that I want. I'm almost finished the car now. I have been tinkering with it for the last 2 years. Hopefully I can get some photo's up to show.