WANTED ITEM:
Extractors / headers for an A14 motor (with a round-port head).. though i don't suppose it maters..

CONDITION:
Any..

REASON FOR wanting:
I have an Austin A3) in which I am putting an A14. IT is a real tight squeeze down low and at the back near the box (though with oodles of room up high near the ports). THus I am ideally after an old pre-loved set that I can play with and perhaps 'persuade' to fit with the help of a whole lot of heat and a big bar... ANd ideally, ideally, I'd like a set that ran as close to the engine as possible... (but anything is better than nothing...)

PRICE AND PRICE CONDITIONS:
cheap cheap, and any condition (as long as they dont have holes!) as I may well end up killing them in the process

LOCATION:
I am on the Central Coast (NSW), so can get them from Sydney, Newcastle or even further (perhaps via post) if need be.

PM'd

pm sent.