hiya folks... need advice big time! tried n tried but failed...

ok here goes...

I bought an aftermarket central locking module along with it actuators for all 4 doors, i also bought a standard alarm so that i can use a remote instead of having to use a key to lock and unlock the doors.

I first wired the central locking in to all 4 actuators, and it works fine.
now there are 2 wires from the central locking module which is not used, these 2 wires connects to the alarm module.

Now just for test purposes, i did not wire the taillights/door switch and ACC wire. I only wired the power, ground and 2 wires which goes directly to the central locking (blue and green).

When i press lock on the remote, all door locks except the drivers door.
and when i press unlock nothing happens.

i observe that when i manually push the drivers door down(locking it) and then press the unlock button on the remote - all doors unlock except the drivers door.

its a zig zag now with a scrwed up drivers door! im not sure why.

in short - when drivers door unlock, all doors can be locked via remote and when drivers door is locked, all doors can be unlocked via remote.


what am i doing wrong ? should i connect all wires maybe door triggers??

do advice folks....

here is a link to the wiring diagram from my alarm and central locking unit.

http://img190.imageshack.us/img190/7131/13092009441.jpg