Bits for sale:

- Original A10 engine. Was in running order but with a blown head gasket (had a minor water leak into one cylinder). It needs a new head gasket and a couple head bolts. Easy repair. $200

- Used A10 clutch and flywheel. $20

- Datsun 1000 coupe seats, front and rear. Front is missing the head rests only, rear is complete. Both need reupholstering. $Free

- Datsun 1000 steering column to dash mounting bracket (2-piece). Also have a factory-looking plastic plate that mounts over this and permits the installation of two switches. I haven't seen one of these plates on any other 1000 before. $20

- A10 carbie and original inlet manifold. Good working order. $30

- Datsun 1200 ute brakes (not complete). Includes the backing plates, slave cylinders, mounting hardware, springs, etc. I had to ditch the shoes because they were oil soaked due to a faulty axle seal. Would suit someone looking for a rear brake upgrade without going overboard. $50

- Standard A14 inlet and exhaust manifold. $10.

All located in Maryland NSW (near Newcastle).

Also:

- Datsun 1000 front hubs in perfect nick. These are the same as 1200 drums hubs and has a -5mm offset compared to 1200 disk hubs. Ideal for anyone mucking around with a brake upgrade and wants a different offset. Nissan U12 front rotors are vented 256mm hat style and fit straight on. U12 rears rotors are same dimensions and solid. $20

- 6 inch subwoofer. About 8 years old but never used. Comes with a Pioneer 2 channel amp. $30

- Microtech LT-8 ECU. Apparently in working order but I haven't had it running myself. I'm not sure what these things are worth these days. Make an offer.

Pm sent your way!