hey guys with the ca18 what is the best way to do this, I got the vacume hoses that used to run in the original intake (inlet manifold) it splits from 1 into 2 and going into the inlet manifold

not sure if this makes sense? and it's not the charcoal canister or the tiny hose ones under the intake

any advise on wat guys have done or to do as I'm not using the standard intake crap

get on nissansilvia.com and look up a vac diagram, if your running the secondary butterflies you need to run the vac setup

its the air reg that sucks the heat from the intake pipe to heat up the engine quicker then shuts off when the engine is warmed up.. can I just recirculate these? or they need a vacume? if I disable it it will make my idle control play up?

and I've looked every where I just have not found exactly wat I need to know..

you talking about the 3 barbs underneath the thottle body? 2 are water and one is where the charcoal canister hooks up

to run u only need vac to fuel reg and blow off
block cold idle valve ( its for a higher idle when cold,ignition supplys 12v to
heating element inside valve witch heats a bimetal strip witch shuts of valve
and drops idle over a small amount of time)dont need.
idle control soliniod needs to be connected to inlet duct before throttle body.
butterflys in inlet dont need to be connected and can be removed and welded up.
a lot of crap can be removed