So any experiences?
Im sure they need work but do the doors fit or the ute tailgate im also looking at the ute quarters.
Let me know your experiences.

What could it cost for new quarters welded on the ute?

i went back 3 time with aftermarket doors, in the end i had to use washers to bring them out to line up...you think your doing well by getting cheap panels but there more a pain in the buttox, 1/4's try a few P/B for quotes, not unless you have a mate

after market tailgate fitted fine my ute. 120 bucks to my door; cheep

Front guards, there's a small lip that is a little long on the inner guard section, will take pics, can email if need asap, pm me if so! If not I'll post up some stage tomorrow!
I had to cut a little off of the inner guard, open door and cheak, you'll see where hits first! Trim to suit!
Also fit rear eye bolt first and stretch a little as needed!
Then you need to put all other bolts in loose!
Once all in and good matching to doors and bonnet tighten bolts!
The only place I had to shape was near the cowl as it sat a little low when I lined mine up!
I also had to press a little on lower section near doors till sat right!
Hopes this helps

Hi guys has anyone had anything to do with panel house in qld,thats where i was thinking about getting doors from.$250 each.

why qld when there's a panelhouse in wetherill park and condell park sydney!
plus you find they also don't like freighting them as there's a chance carries knock them around

Wetherill ment to be good
I'm pretty sure they all come from the same twian factory! As far as I've been told only 1 supplier

Along these lines, looking at getting new floors for my ute. I have seen the ones on ebay, but due to the negative feedback in here, was looking for something a little better quality.
I am in Perth - and would prefer to avoid posting them for the reasons stated above

The floor pans arnt twian made! There's a person on here that make floor pans, think he's the bloke that does the lower guard and sills on eBay! I think!

New doors or floors? I have a fair few new panels still available if your keen. I bought double from wether hill panels and freighted over... I your interested pm me with what your after and I can send u the prices...