Hi Guys

I am just thinking on putting a little big tyre set for the b210 just like 165/70-13 or 165/80-12 but currently i am using 155/80-12 yet sometimes the tyre is touching the shock absorber while hard turning ,what should be the solution for this how can i sort out this issue ?

thanks
regards
sumith

Sounds like wheel bearings are shot, jack up front of car ,grab wheel top & bottom,push & pull. Should be almost no movement.

might be the tire wall flexing under hard cornering thats touching the struts

Maybe, but I think any flex happening [at contact patch] would have corrected itself by the time it got to shock absorber body [180 degrees away], even on this rocket.

Sounds like something not right there. Is this on 120y or the b310?

Sounds like wheel bearing to me as well

Hi Guys

This is my 120Y , when i look down the wheel from inside it sees the tyre is almost very closer to the shock absorber body.i will upload a snap probably on monday, how it looks

thanks
regards
sumith

Maybe wheel off set is the problem

Yes, something is WRONG.

In a stock B210, there is no possible way this can occur. The stock 4x12" wheel positions the tire far, far away from the strut tube.

* Wheel: 4x12" +30
* Tire 155SR12

Hi Guys

Look at this and what should be done to avoid this am i using different Shcoks or what is wrong here ? i think i would not be able to use higher rim size like 14, yet it will touch the shocks

thanks
regards
sumith

Attach file:

---

  1.jpg (69.17 KB)


  2.jpg (78.38 KB)