Bluebird EI

Revision as of 01:07, 14 December 2012; view current revision
<-Older revision | Newer revision->

Australia-produced Bosch Electronic Ignition from the Bluebird Series 2 can be adapted to the A-series engine.

Overview

photo

22100-V9610
U-PGFU 4 -> 349
520

Bosch distributor was used only on the 1983-1984 Series 2 Bluebird, in Australia

4-pin connector
large cap
cast metal ignitor box

To get the best from it, you will need to use the matching high energy type coil. That will really make those plugs throw a spark

DatRats did conversions to A-series when they were still operating.

Modifications

Machine off the flange and lathe to proper diameter then cut to length.

• regraph
• test
• add A-series cog

photo

NOTE: Although it looks different, both L-series and A-series distributors rotate anticlockwise when viewed from the top.

Clamp

After lathing the distributor shaft, a hold-down clamp must be fitted.

DatRats fitted a billet aluminum hold-down clamp:

But an Austin clamp possibly could be used

Wiring

Just remove the ballast resistor, re-join the wires and voila! electronic distributor. Never renew them bloody points again!

Photo Index