available on Ebay australia item # 131202371450

$10.50 + $10.00 post

post to US should be reasonable as it weighs stuff all

I THINK it is M14 1.5 not easy to find in a pipe socket plug (flush fit)

if you are wanting to plug the rev switch hole, you can put a grinder through the switch near the wires, remove the rod and spring, secure the hex bit in a vice, drill & tap for M8 1.25. Then carefully cut the threaded section from the hex section. Grab am M8 1.25 bolt, cut a screwdriver slot in one end, trim to length, screw and loctite into the newly tapped bit. You end up with a flush fitting plug with a handy slot in the centre.

The rev switch thread is parallel (not tapered) so some thread sealant would be wise to make sure the plug does not fall out or worse, fall into the gearbox.

chasing a towbar to fit WHB310 Sunny Wagon

Reuby, pretty sure I have something suitable to donate to the cause

what sort of fasteners x 2 are used to secure the plastic trim over the handbrake?
are they bolts, coarse self tapping screws or fine self tapping screws?

looking for a right tail light for a late model SUNNY WAGON WHB310 (square headlight model)

PM sent

well above average, very straight, minimal rust.
also have a H165 4.6 centre
call you Sunday Morning

I am driving back from Geraldton Sunday so might se you in Midland. Whats the address?

Nigel front bumper is straight
Rear bumper lòoks like your face!