Browsing this Thread:
1 Anonymous Users
|
|
A15 block decking |
|
Home away from home  
Joined:
2015/11/10 17:48
From Fort Worth, Texas
Group:
Registered Users
|
Its been a while since I have posted. Finally got my engine back from the machine shop. I noticed the engine block deck is pitted in certain areas. Do I need to deck the block or will the head gasket take care of any imperfections? Machine shop never brought it up to me and I didnt notice it till I set it on the engine stand. Also need to find a supplier for piston rings and bearings. Piston bores were within tolerance as well as the crankshaft. Block was not hot tanked so that I could reuse the cam bearings. One of the images (A15block4) shows a brass plug in the center. This is stock from the factory or was the block modified?
Posted on: 2016/6/6 5:57
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
A15block.jpg (86.10 KB)
Transfer
