Bugger!!!!!!!!!!!!!!!
wish i didnt sell the efi now
.
is that to suit a round intake port?
not hard to do an oval port i guess!
nice job!!

exhaust ports are exactly the same on round and oval port heads. its the inlet that is different!

Still waiting to see one on a car with turbo on Or a measurment for the width of the manifold!

Pardon my ignorance, but this suits A14?? Thanks guy,s.

Yes suits A14, A15, A12, A10, etc.

Thanks SD

still havnt got a good chance to fit it to an engine but i got a few more piccys and some measurements, the manifold itseld is about 17cm high and 12 cm wide and 37 long, and with the t25 on its 25 high by 25 wide by 37 long hope this helps

some more pics

can you get hold of tnese manifolds for the l series engines

na there only for a series

Just did some measuring in the 1000's engine bay. Looks like bad news. 25cm down from the top of the flange(head side) and 25cm out from it is the middle of our upper control arm! We can only go around 18cm out maximum, or mount it higher.

I might get in contact with the bloke i was gonna get to make my quad bike carb manifold and get a quote. High mount sticking to the block and make a highish plenum for it too.