hey i seen these they look alrite i wudnt mind gettin one but bit to much for me, does anyone wana help me out?? if anyone gets some made up who would like to sell me one?? Pm me THANKS Appsy1

Howdy,

I always sell my stuff cheaper to datsun1200.com members so i can let them go for $70.00 + $15.00 postage off this site (not on eBay as their fees are $7.50 for listing/selling! + 2.00 for paypal payments). The price is a bit high as this is my first lot, the cad drawing and measurements cost me $150.00 for the setup not including the cost of the cut pieces. I am actually looking to take some orders on Stainless Steel ones. These would be a bit more difficult to cut gauge holes etc but would look pretty sweet.

These arent easy to make, but if you have half a brain, some patience and some time of course, anyone can make one. The top part of the piece is curved from end to end, the bottom is flat and the right side is shaped to fit as can be seen. This is to help you guys out so u dont have to make up too many failed templates.

If 10 of you guys or your friends can get together i can do a group sale on datsun1200.com for $65.00 + 15.00 postage for stainless steel ones. Pm me or post here.

heres a pic of mine ... i made it out of mild steel because i wanted to weld the lip around it but next time i'll probly make it out of stainless

welded and painted



lasercut blank

Nice job mate, looks good! Let me know if you want one in SS