For several years now Datsun A-series enthusiasts have been asking us to make components for their engines. Some local Florida owners lent us several blocks and were very patient as well. Here are a couple pics of the windage tray and crank scraper:







Kind regards,

Kevin Johnson

Ishihara-Johnson Crank Scrapers

Can I have one for an A15 (82mm stroke)
Shipped to Perth Western Australia ?

what do these 'crank scrapers' do ???


Mitch

thats pretty amazing, something else to now a bit about.

MITCH

I did not have time last night to upload the pictures of the pan baffles. Pretty straight forward items. I noticed that both attachment ears of the stock baffle were broken in the pan I measured so I made them from a heavier gauge of metal. I added trap doors to that piece too. The new item is just an anti-surge baffle for the rear of the pan with a trap door.

They look good too
But I need to mod my sump for ground clearance so I'll do something like this while I have it out and shaving a few inches out of the overall height

Recommended floor to pickup intake clearance range is .250" to .375". That's something you might have to watch and adjust depending on what you do.

they're around $50 usd. not a bad deal if you need a new toy ;)

I need to run it by the engine builder first
I think we'll be going knife edged crank which means this scraper might not work
But the windage might still be a go