has anybody gone and had a look at this car click this link
it seems bloody cheap. if someone has gone and had a look can u please tell me whats wrong with it etc.

bottom left hand corner has a mod plate for some mods, maybe not all of them. says nothing about brake mods, but paint looks like spray can job metalic flake, not custom.

not bad for price, expect it to be a bit rough though

looks like the hole car is a bit rough

home spray job ?

You would need to get it right for NSW engineering for starters. Honestly Don't see that as being a good buy. Paint looks terrible and that's me being nice. It goes and drives so hes one up on me at present HA HA.

hahaah yeah true. i can get engineering done for very cheap so that wouldnt be a problem. i just wanted to know whether it had any rust etc....most peopl eif u ring them up and ask they say no but then when u go over the whol ecar properly u normally find some.

Well i have given up asking if theres any rust i just say How much rust has it got. Also Do you know a modified vehicle engineer who is on the list of RTA engineers in your area ? Or just someone with an engineering shop ? There is a difference, No offense intended there matey.

a local car, but i haven't seen this ute on the road

nah hes rta registered. been a long family friend.

just wanted to find out whether its worth going up to have a look.

i wouldn't bother from the look of those pic's its deffinately a rattle can job, and not a good one at that lol. Although the hard work of the conversion is done, you don't know what corners have been cut. Rust was probably bogged, if the guy was cheap enough to use a rattle can than that doesn't say much for the quality of the rest of the build. Be careful but go and look at it for the rest of us lol...