hi everyone, been out of the datsun's for a while, this is my new nissan 1400 ute, it's a 1993 with some new paint and a stock a15 and 60a 5sp. plans for now is just finish the interior and a few odds & ends

Attach file:

---

  nis1.jpg (126.82 KB)


  nis2.jpg (120.36 KB)


  nis3.jpg (142.40 KB)


  nis5.jpg (129.57 KB)


  nis6.jpg (120.72 KB)

wheels and paint look nice. get a shrome front grill and lower it maybe with wheel flares

i suppose the roads might not let you lower it too much over there.

Nice Welcome back.I soposed Datsun sedan steel grille is rare or expensive.

the grills are quite rare yes, as most datsuns in south africa are falling to pieces but still driving and the front apron is different on the square lights. got the door bushes from nissan this morning, R16 a bush, which is very cheap. snowing here for the first time in 17 years, gotta love how these cars just start right up in this weather!

So I got the door hinge bushes, only to realise the doors does not have a pin and circlip that you can remove, the shaft is welded on the top hinge and bottom is only a shaft that's also fixed. Any ideas on what I could do? Nissan does not sell the pins or the circlips

Hi all, so ended up buying and fiiting complete hinges, doors working perfect now. Also got hold of a geniune gx head en a set off twin hitachi flat top su carbs and put that on

got my head back for some upgrade, it's a h89 with stainless valves, double springs and ported to gx size and flown. also got some 40mm webers that will be going on with this and waiting for the reground cam

Attach file:

---

  resizehead1.jpg (142.19 KB)


  resizehead2.jpg (97.28 KB)

also got some interior done, as i bought it with no panels or ceiling

Attach file:

---

  resizeint1.jpg (129.40 KB)


  resizeint2.jpg (127.69 KB)

Nice head just clean those valves, look a bit gummy

thanks, it might be pic quality, or what do you mean by gummy? here is a close up, just plastic covering it

Attach file:

---

  resizehead3.jpg (103.93 KB)