Yeah, I try keep everything original looking to a degree, these are quite like zcar seats, comfy and supportive.

Im holding off on updates on the racecar because Ive had a few setbacks with money and such, also bought a house last week so things have been hektic.

Got a complete L16 setup for this car, that will be going in very soon if not this weekend, Its got dellortos and a mild cam, Im sick of blowing smoke everywhere!

hmmm your L16 sounds like it would probably go harder than my L20b, stupid low comp peice of crap

oh and i should have a nice stock of L18s soon to put in 1200s, or was i supposed to be collecting crossmembers

EDIT, oh and nice clean looking seats too

Yeah this L16 should go hard, I set the whole lot up today, looking to just lift the car over the engine crossmember and box and bolt it all up over the weekend, hopefully!

L18's are hard to fit though, the sump is at the back, you'll need bluebird sumps and pickups in the masses! Where are these L18's coming from 180b's or 720 utes?

Nah I was collecting crossmembers you were modifying them, then everyone can get rid of those horrible rubbery pushrods.

sumps can be modded, and pickups custom made, and holes drilled in the block for lipstick

think they most of them are from 180bs and one from a 720....as im getting a 180b and a 720 with them