hey mate,
What trans tunnel did you use???

hurry up Laney!!! im only 2 hours drive up the highway i wana check it out when its painted

first answer is nar its not painted yet but getting closer. .
2nd the trans tunnel is a laney special lol made on the spot lol. . and hopefully in the next few weeks their will be a new set of wheels sittin here at home for her when she comes back
thanks boys

colour is black and its going with all that cause the guards are being rolled so he needs to see how far and the rad cause need fitment brackets and intercooler is the same deal top brackets they have my chaser rims lol. . see im not stupid lol

Hey Laney,

Ute's looking good! finally got the roof sorted I see...

I looked through your pic's etc. Couldn't find anywhere if you had said what sort of front end your running. brakes, struts, hubs etc. I wanted to run Holden pattern too.

yer mate commo Vlturbo/ v8 disks and callipers

by the look of it the same as the engine bay
your missing a bonnet

is that a cab chassis?

how much work was involved in that?
ive oftern thought about what one would look like

to much work ohh lol the chasie has been fully welded and boxed in so its strong theirs a80x60 suport joining the 2 top rails and thats welded to a 3mm thick 90 angle that runs from right to left then inside the cab theirs 2 tubular bars off the 80x60 suport down to the front floor and side walls and bottom chasie link has been fully welded to the budy from underneath. . new bonnet is on its way

holy moly

u rock dude... i so need some more experience with a welder.

should so buy that other tray back one on ebay just so your the coolest kid round with 2 tray back 1200 utes