Hi huys im after the instument cluster out of a ca18det equiped 180sx or silvia dose anyone have one left over from there front cut that they want to sell?

Hey mate im using 240k struts with hilux 4 piston calipers and ledgend dics

Hey mate try Stylerod panels in croydon or sheen panels in ringwood ive got mates who work at both who do a good job

Cool mate if im not there buy 8.30 just go without me and il meet you there ive got the engineer comeing over this weekend but he hasent told me if its going to be sat or sun yet

Hi guys ive just finished fitting my engine and modified my tunnel to fit the ca18 five speed.All in all its not to bad and only took me a day to do as long as you have acsess to a mig welder and basic tools.Her is a set of instuctions that I used

1.Reove the original gearbox mounts from inside the tunnel.I drilled out the spot welds then used a air chise to get them out.

2.From the rearmost point of the original gearstick hole measure back 200mm.From this point cut horizontally across the tunnel.Then cut down the sides until you reach the little steps in the tunnel.

3.Place the garbox on a jack and fit it into the tunnel this shold push up through the cot you have allready made

Then all you need to do is trim off the excess metal and make a box to go over the hole with 1mm sheet and weld it in.You will also need to cut a new 90mm gearstick hole

hope this helps

Got some seats for sale that came with my ute not sure what there out off.Their one piece with headrests dark blue in colour in ec
$100 ono can email pics on request.

seats are in melb

Hey mate 120y booster bolts straight on then use a 240k master and you shold have no problems

Ive got one mate its in melbourne but let us know if your keen

Cool mate your wouldnt have any pics off the dash would you.Dosent matter if you dont whats your email adress so I can tell you where to send it

Hey mate il come down for a look be cool 2 seen 1200's hitting the strip let us know what time you are going and i can meet you at your house