21st works for me

I took my leaking heater core out of my coupe to a local radiator repair workshop and they replaced the core.

The wheel well looks good in the sedan, i just have to check the condition of the my coupe shell. From what i remember the coupes not to bad and i think it just needs a patch or two. Let me know if you need any other bits for down the track, its got a reasonable headlining if you need it, basically anything that does not fit on a coupe will have to go.

Let me know if you need anything for this, i am dismantling my sedan and the body will most likely be cut up and disposed of.
i will be keeping only the parts that fit my coupes.

I ran trx rims for a while on my coupe and sedan, both could use a 195 tyre on the rear but they would rub on the struts on the front so needed to run a 185 or spacers. And like Demacoz said the profile was an issue.

Edit: That was with coilovers, so not without modification.

I am here for datsun and car related stuff, there are plenty of other forums around for freedom of speech garbage.

Keep it car related and you will keep the forum alive for a while yet, keep going down the current path and you will have killed the forum.

Anymore of the same and i wont request my account deleted, i just wont come back. Simple

How much are they for a set?

How did the test go?

hahaha, yeah that wire isn't going to be there long. They appear to have them on Ebay.com but the postage is a killer.

Could you call someone like a motor rewinder? They might know where you could get the right sized carbon brushes, you might have to alter the copper cable on it.

Or maybe something like this.
https://www.ebay.com.au/p/16022838036? ... 8gtkRLdyCsMRoCSfsQAvD_BwE