Quote:

as ddgonzal said in his post before you wrote this, the stock conrods are forged.
there are plenty of high output A15s which use the factory conrods.

Just get them peend and polishd for a little high RPM peace of mined

Okay so I will stick with the stock rods as they are more than enough for even the most powerful NA A15 motors.So should I get the forged flat top pistons then??????My A15 is near new so the bore is in amazing condition just like the rest of the motor so I was thinking of getting the pistons in the standard 76mm bore but with the compression at a healthy 10.5-1

in my opinion:
for an all out racing engine, get forged pistons.
for a roadgoing engine, save some money and use cast pistons.

Where would I get after market cast pistons though??????
I am planning on getting the pistons from Paeco in America has anyone used their stuff before??????