Want to borrow a non-emmission idle jet holder (any 7850.1-10) to compare against my emission version. Will only need it for a couple of days.

I think I can fill and drill my cheapy emission carbs to run std idle holders so just want to measure one up before splashing out and buying a set (and drilling holes )

Level has a whole heap of parts. Whitesedan, an Adelaide member also has a few that I may borrow on your behalf. Let me know if you'd like me to ask him.

EDIT: LOL, Level? hardly..... I meant Levey.

Thanks Chris,

If I can't find anything locally then might have to take you up on the offer of help.

Or even a good close up photo of a non-emission idle jet holder next to a ruler with a millimeter scale.

Got some JB Weld and itching to have a go!

I can take some more pics if you need but as for parts I had to give most of those back, I still have have some though.

Thanks Levey.

Just a pic lengthwise of the idle jet assy next to a ruler with mm scale should be all I need.

I want to make sure the threads are in the same place as the emission ones before I fill the old pre-sized air bleeds in the carb body jet stack and re-drill them lower to below the thread.

Cool Dean.

Going round to Sean's this week to drop of some parts, let me know if you want me to ask him cheers.

could come look through my spares, chirnside, is that the standard carb or another?, ive never mezmarized those funny carby letters?

pm me to organise a visit

[edit] i googled it, they are twin delortos, hmm i have a set of twin sides but cant remeber if they are weber or delorto, just that they catch fire

Catching fire! Thats not great!

Hopefully these won't do that to me after I have finished drilling holes everywhere..

Is this what your after?

Attach file:

---

  Idle jet assy 1.JPG (103.84 KB)


  Idle jet assy 2.JPG (99.17 KB)