Cleaning out the garage.

I have a small batch of A-Series engine parts that have been collecting dust on the shelves in my garage for about 40 years (since we quit SCCA racing a Datsun 1200). There is pretty close to a complete 1200 race engine. I believe that the parts fit DATSUN 1200, B10, B110, B210, B310, A12, A14, A15, etc. Many parts are NOS (New Old Stock). Many of these parts are still in their original factory box.

I'm not sure on the value. I'd like this stuff to go to a good home. I would prefer to sell all of the parts a lot. If interested contact me to discuss / make offer. I can arrange shipping from Escondido, California, USA, at buyer's expense.

Parts include:
Carburettors, Mikuni Solex 40PHH complete w/ Carb Insulators, Intake Manifold, GX, Throttle Linkage, Heat Shield, Air Cleaners, Velocity Stacks

Manifold, Intake, Datsun Competition Oval Port (NOS)
Cylinder Head, Oval Port / Big Valve (NOS)
Head Gasket
Intake Manifold Gasket, Oval Port

Valve Springs, Iskendarian, Dual Coil (NOS)
Cam, Iskenderian (NOS)
Lifters, Set (NOS)
Pistons, Set, Venolia, Forged Al, High Comp (NOS)
Wrist Pins, Venolia (3 Sets) (NOS)
Pistons, Set, GX,, w/ Wrist Pins (NOS)

Connecting Rods, Set
Crankshaft
Block

Oil Pump, High Volume, Datsun Competition, w/ Remote Oil Cooler Ports
Timing Cover (NOS)
Cam Timing Gear (NOS)
Timing Chain (2) (NOS)
Tensioner, Timing Chain (NOS)
Water Pump Pulley (NOS)
Rear Main Seal
Main Bearings
Rod Bearings

Datsun 1200 Competition Parts List

Here are pictures of most of the parts:

PM SENT.

Oh man, what a list. Shame I've already spent too much money this year :(

Good luck with the sale, I'm sure you'll get plenty of people wanting to snatch these bits up.

Some of your pictures seem to be broken too.

PM sent also

If you would consider selling the camshaft and trumpets for the side draft carbs separate, I would be interested. My postal address is in NJ.

Also the GX head gasket and GX intake gasket.

Very interested in these for my restoration project.

Thanks

FYI Jeff (geoff?) The carburettor trumpets pictured MIGHT be suited to the 36PHH Solex Mikuni Carburettors pictured (mistakenly labelled as 40PHH which shares the DCOE DHLA bolt pattern) the 36PHH pattern is that of the DHLB and DCOF patterns so you may find they are not applicable to your carburettors (best to check first).

The carbs fitted to the manifold are 36PHH Mikunis on a round port manifold, any true 1000 enthusiast would recognise this assembly as the Solexcel upgrade offered post factory by (SOL) EXCEL. These seem to have been sold by the competiton department in the states but not listed in their catalogues (I think).

Here is another set for sale- mistakenly advertised for the second time running.

They are a good upgrade for round port motors. I run the DHLB variants on a round port small chamber A14 and it hauls ass. I intend to fit a set up to a worked A10 that I've had stashed.

SOLEXCEL Upgrade Induction & GX Exhaust: