Browsing this Thread:
1 Anonymous Users
|
|
help with making a quad throttlebody inlet manifold |
|
Just can't stay away  
Joined:
2003/7/8 15:15
From Adelaide, Australia
Group:
Registered Users
|
im trying make my own quad throttle body inlet manifold for my A14. im trying to use 4 throttle bodys of a late 90's hyundai excel and adapt them to a twin webber manifold. the butterfly of the T/Body is 40mm which i gather is a good size but the tunnel of the T/Body (towards the inlet side) tapers out to about 50mm. will this cause a problem bolting up to a webber manifold? does it matter that it tapers out to 50mm and then get it to taper back into 40mm. i hope u can picture this
Posted on: 2005/7/10 7:58
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
