well the new house has pretty much been aquired and it doesnt quite have the spare 10 acres to keep parts on
so its time for a clean up

pair of rebuilt 60 series landcruiser 4 piston calipers, bolt straight on to stanza 200b or 240k struts and suit a 250-255X18mm vented disc
SOLD

R31 diff housing, cut down to suit 1200 has mounts to suit sedan(shock bolts to diff mount) also has all brake line mounting points and sway bar mounting points, will go into all 1200s and 120ys
20mm wider than standard 1200 diff width to centre the TRX mags i was running, no axles centre or gears but if you had a complete R31 diff you would only need to spend another $100-150 on getting an axle cut down then if would be ready to assemble and drive on
$300considered SOLD

new stanza front brake lines cost $70 for the pair, $35

180bsss SUs(hitatchis) with manifold and linkages, were running fine on my car till i upgraded, $70
also have a spare set of carbys if needed
SOLD

pair of r31 rear brakes, crossdrilled rotors and rebuilt calipers. one of the calipers needs a new bleed nipple thread
SOLD

pair or 180b struts with no brakes, good to use in 1200s and stop pretty quick with commodore calipers and magna discs

pair of sunny struts with no brakes CUT UP FOR RESEARCH

pair of bluebird struts with brakes, like R31 but without the different stub axle angle

180b crossmemeber with LCAs and such, for converting 120y to L series

4 14x6 chevoit gold mesh rims, good offset for 1200 SOLD

numerous 14x6 and 14x5.5 steel rims

4 late model a12s, 3 of which should run fine with the right gaskets and seals

2 120y crossmembers

200b crossmember redrilled to bolt into a 1200, starting point for L series conversion

near complete 180b aircon setup

2 pairs of 1200 rear seats, suit re covering

2 standard ute seats

KPH 1200 sedan dash SOLD

many L4 engine parts

200b sedan grill headlight surrounds and taillights in GC

1200 sedan LCAs steering arms tierods

3 stock 1200 sway bars

2 h150 tailshafts

h145 tailshaft with replaceable unis SOLD

L18 flex plate and convertor

56a 4 speed SOLD

1200 ute U bolts and shock mount plates

new 20/09

stanza front gas shocks in GC

1200 sedan rear gas shocks in GC SOLD



also see my wrecking thread

more stuff will be added as i remember that i have it, and pics can be supplied on request

things with prices are all ONO, things without are open to offers

pm me or reply to this thread

do you have an A15 intake manifold?

the 180B Hitachi SUs - round top?
mind posting them to Brissy?

no A15 stuff

both sets of hitatchis are square tops, postage is no problem

If those Landcruiser calipers are rebuilt as you say then consider them SOLD!!

yes they are most definatly rebuilt, even have a brand new piston in one of the calipers (had a bit of a mark on one of the old ones)

got a good working headlight switch for 1200?

what about good drivers side 1200 sedan seatbelt?

carpet for 1200 sedan?

1200 sedan front seats?

i can help with headlight switch if needed

got plenty of headlight switches

got a drivers side seatbelt, would have to check condition

got red sedan carpet

and have 2 pairs of sedan front seats, one red one black, but i think both have ripped trim

i may have to come visit.

what do you have in the way of parts for a manual conversion into 1200?