TRX Wheels

(Difference between revisions)

Revision as of 04:54, 22 July 2016

Alloy wheels from Datsun 910 "Bluebird Series II" Australia TRX package work nicely on a Datsun 1200.

Overview

Album 6501 Album 2005

Album 14785 Album 10190

TRX

Nissan Bluebird TRX rims

album

15" wheels, 5.5"(?) wide, Offset +35

Discussion: will trx 15"rims fit straight onto 1200 ute without flaring?

"If I see another 1200 with TRX rims I'm 
going to smack you across the face!" 

On standard Datsun 1200 struts they will require fairly low profile tyres, and quite large spacers for the front and it will need to stay at standard height. Even then you might find they are a tight fit and might grab the guard a bit if you hit any speed humps too quick or take corners quick.

If it is lowered at all you will need to roll the guards for sure!

TRX wheels on 1200

With Stanza and other similar struts they fit no problem with 195/50R15 tyres and will only need to cut the front bottom corner out of the front guards for clearance when turning.

With Sunny (B310) struts on front and 195/50R15 tyres, it requires to roll all the guard lips, and run spacers on rear as they were scrubbing the inner guard and on all wheel arches the sharp lip all around the guard was tearing into the tyre slightly so rolled it right up.

Source

Datsun 910 "Bluebird Series II" Australia TRX package

Japan TR-X

15x6 Offset +35

レパード TR-X Nissan F30 Leopard TR-X 8009-8602

F30 15x6 Aluminum
N1 TYPE アルミ　ホイール
40300-F6025 ** F/AL KEYLESS 6JJX15 *L20E# 8406- 4
40300-F6026 ** F/AL W/KEY   6JJX15 *L20E# 8406- 1
40300-F6027 ** F/AL KEYLESS 6JJX15 OFFSET 35  VG30T 8406- 4
40300-F6028 ** F/AL W/KEY   6JJX15 OFFSET 35 *VG30T 8406- 1
40224-W1505 NUT-ROAD WHEEL $19.10 USD
* K10,910,B11,E23,F30,R30,M10,S12,U11,Z31
* USA: nut used on S12,Z31

Wheel Nuts

TRX wheels use a taper-seat nut. About 7$ each from Nissan, or $3 each from aftermarket sources. Can be purchased at wheel shops too.

There is 2 different types of trx wheels (series 1,2 + series 3). There is a extra small lip on the inside of the stud holes on series 3 and so the nuts differ a little

TRX Wheel nuts

Factory TRX nut at left, either kind will work

Aftermarket nuts can be used. Taper-seat Nut longer taper area required

Datsun 1000

album

Photo Index

Posts
Post 414506 Post 294105 Post 295223 Post 417185 Post 347116 Post 347116 Post 286908 Post 321594 Post 404889 Post 408605 Post 314365 Post 360499 Post 347075 Post 347076 Post 387263 Post 387986 Post 388189 Post 397461