[< Previous 629 630 631 632 633 634 635 Next >]
Sprinter Diff Conversion
 rally1200  2005/5/2 15:07  Tell a friend
 3646  1  0.00 (0 votes)
| Pic of the Double row wheel bearing i used in the sprinter conversion. This conversion could be used on a standard H165 diff |
|
|
[< Previous 629 630 631 632 633 634 635 Next >]
The comments are owned by the poster. We aren't responsible for their content.
| Poster |
Thread |
| Dodgeman |
Posted: 2006/3/16 5:23 Updated: 2006/3/16 5:23 |
No life (a.k.a. DattoMaster)   Joined: 2003/6/27 From: Southern Tablelands N.S.W. Australia Posts: 8287 |
 Re: Sprinter Diff Conversion OK, I know that this is an older pic, but certain questions must be asked.
The part number of the bearing?
Is it the standard ID & OD of the original bearing? [I guess it is but need to confirm.]
What rear axle housing did you use it in? [1200 ute, Blurbird etc.]
I presume that it was necessary to machine the bearing bore in the housing a bit deeper. If this is so, then by how much?
Any other info will be much appreciated.
{EDIT} OK, i looked at the other pics. I still presume that this could be done with a Datsun rear axle, would this be correct?
|
|
|
Mechanical
Drive Train