As they won't suit my in intended purpose I have decided to put of my set of extractors on the market. they are a rare 4 into 1 style and are designed for a 1000.. they might also fit a 1200 but on a 1000 they clear the steering joint by about a centimetre. oh and they are off an A15.
they have been painted with a heat proof coating several years ago and are showing some light surface rust. I can post some pics of them in my old B10 when I can find them.
I am asking $250 as they have seen less than a year of regular use and it would cost over $700 to have a set like these fabricated. freight would be about $40 off the top of my head to any of the eastern states. Obviously Perth people are welcome to pick them up.

hey Shoom
Do they fit a b10 with an a10 or a12?

not the A10 but they would only fit an A12 if it were the GX engine with the oval ports

hmm just looked at some pictures of manifolds on here and it appears that the exhaust ports were in the same place on all variations of the A series , so they SHOULD fit in theory. also if anyone in Perth buys them I will throw in the 2 inch exhaust system that was on the car, which is fine but I had to cut it in half near the diff, to get it off the car.

found a couple of old pics of them installed in my old B10




and

PM sent

Just to let everyone know these are for sale again as the original buyer had a change of plans.
I do have some other 1000 bits to sell and am very negotiable on the prices if it goes in one lot. I will get back with a list later.

Pm sent, I want them!(the extractors that is)

<--- Look into my eyes.....You want to sell them to me....when I click my fingers you will call me....

can i have the exhaust? well but it

Just to let everyone know these have been sold. thankyou to everyone who showed interested.