Well done, Great site and great products.
I think you will be well supported. looks like very good quality and price.

We have 10% discount offer for the next week just enter the discount code 1200 and you'll save 10% on your purchase.http://automotivepanelcraft.com/

bump

not a bad site and the prices not too bad either. need some sedan rear 1/4 bottom part of the panels there. they always seem to rust there. ebay has them for $44 each. im sure you could do them too.

I wish I knew of you when I was doing my rust repairs.

I tell ya what mate, that's bloody good value for those prices!

bloody great site you have, hope you do well from all this sites users.
i for one will tell all dato owners i meet about it....

I'm looking at making some 1600 front and rear floor pans and was wondering what sort of interest there would be and looking for suggestions for more 1200 and 1600 repair sections.

Guys I can vouch for Waynes great stuff, I picked up a set of ute front floor pans and they're great!
Wayne I reckon you would make a killing out of doing ute tray floors. I for one would definately grab one.
Another idea is the inner guard section where the front bumper mounts to. Ideally you could make the inner guard and also the thicker section that spot welds on with the nuts on it for the bumper. These are quite often rusted beyond recognition too.
Again, do these and I'm all over a set! I'm too lazy/incompetent to make any panels myself.

im sure the 1600 boys would love you to make some...when i had mine it needed alot of work (more then my 1200 by alot!) but tis the same with most of them that are original, they rust badly. if you were making all replacement stuf back then i would have kept it