Guys, l made these camber plates to fit into my ute when it was running the standard stanza inserts. Since then l have changed to 240z inserts which use a larger diameter shaft, thus these don't fit.

I'm looking for $130 delivered in Aus, and they are in very good used condition (were only on the car for about 6 months). Will include the 3 chassis mounting bolts, spring washer and lock nuts, along with the 4 bolts and spring washers for assembly (shown in bottom pic).

I can make plates to suit other diameters (currently stanza and 240z) for $180 delivered (or $170 without paint). Again this includes mounting bolts.









Can contact me here, or acryan@optushome.com.au



Thanks
Andy

i'd be real keen to see the ones to suit the z inserts ... i've got some cuscos and having a hell of a time getting these to work at the moment with the z inserts.
also how much neg camber are you looking at getting with your plates ?
cheers

Both plates look almost identical, l just alter a few dimensions for the different bearings.

As for the camber, not 100% sure, but l am sure it's more than most people will ever need!!

I made the design reversible underneath, to cater for all purposes, but to give you an idea, l redrilled my lca to crossmember mount approx 30mm closer to the center of the car on each side (with stanza struts and arms - to maintain correct track width), and with these plates can still get over 2 degrees neg camber.

The bottom photo in the above post, is my current setup with z inserts, and running about 1.5 degrees (from memory).

I think my original calculations (hazy at best), were around 15-20 degrees total movement (pos and neg). Though this depends on neutral start point, struts, etc etc.

I'm serious when I say I'm interested in a set for my stanza struts. They're using 120y top plates though as I didn't want to go cutting anything around the strut towers on my 120y coupe. Pm me if you like

hay andos could you make a set to fit a 1200 ute that has standard 120y shocks fitted???im very interested cheers

evilbetty

Guys, for those that have expressed interest, l'm making the plates at the moment.

So if anyone else wants them, let me know.

I can custom make them to suit any setup (well l can try), so if you want something, let me know.

Cheers
Andy

How is that 120y topplate idea going?

what about 200B struts? i have them, but does anyone else use them, thats the question.....

Hi

I am interested but I am in South Africa.
How do one go about buying stuff that are in a different country and use different currency?

PRICE ON 1200 WITH STANZER STRUTS DELIVERD. THANKS,NEW /SECOND HAND