Panels

The drip rails (drip mouldings) are actually part of the Body Side panels, where the roof attaches to the side.

Also see Body Side Part Numbers

ASSY-FRONT PILLAR
ASSY-RAIL ROOF SIDE OUTER
PANEL-RAIL ROOF SIDE INNER

[edit]

Removing

discussion

You need good door rubbers that seal real good -- the water runs off the side down the side windows instead of in the drain and then down the front or back. Just grind where the spot welds are inside the door opening. and the whole rail will come off. To regain strength, weld the roof skin to the car the full length.

shaved rail
Album 14606

2332's Sunny Truck
Album 13948

Album 14547

flyby's sedan
Album 5974

[edit]

Chrome Trim

All 1200s except Standard trim included chrome trim over the roof rain drip rails.

73800-H1801 SET-MOULDING ROOF DRIP RH COUPE
73801-H1801 SET-MOULDING ROOF DRIP LH COUPE

73800-H1100 SET-MOULDING ROOF DRIP SEDAN 4-DOOR
* Only the rear piece differs from 4-dr to 2-dr
73800-H1300 SET-MOULDING ROOF DRIP SEDAN 2-DOOR

Also see Body Side Trim Part Numbers

SET-MOULDING ROOF DRIP RH
SET-MOULDING ROOF DRIP LH

Each set consists of:

MOULDING-ROOF DRIP FRONT
MOULDING-ROOF DRIP REAR
CLIP-MOULDING ROOF DRIP [Center clip]

To install, place it on the top edge, then snap it down onto the bottom edge
Album 25758
Depress downward after hooking the top

To remove, pull bottom edge out, which will snap it off the rail.

Retrieved from "http://datsun1200.com/modules/mediawiki/index.php?title=Drip_rail"

This page has been accessed 7,726 times. This page was last modified 05:16, 26 June 2018. Content is available under Datsun 1200 Club.

Drip rail

Panels

Removing

Chrome Trim