SOME 13" wheels will fit over S13 calipers. these neg offset superlite do, but most 13" wheels probably won't - they're likely to foul on the bleed nipple.

for those who are interested 12" mags will fit over Stanza brakes - the ones I used were Superlite 12*5".

if you go to a jap wrecker you can pick up 14 inch space savers for 4 x 114 cars from silvias and 180sx'x etc. usually $50 a pop. as long as just for a spare, it will do the job and will be thin enough. Think if you look hard enough might even find them in 13 inch.

My 13x7 -8 (think that was it) superlites fit fine.

I think it depends of the bolt height spacing on the caliper plate. I have u13 bluebird rear discs on my 1200, and 13's fit fine. A mate of mine has the same discs on his 510, and he tells me 13's wont fit. I think it'll work if the caliper is close enough to the rotor.
I'm getting a pair of rotors and calipers tomorrow for $50

Quote:

yeah, that's what I was referring to. Most 13" wheels used on Dattos willl have positive offsets to, so its not a very good basis to say that 13" wheels will fit based on that example.

yea true... BUT MY 13" WHEELS FIT haha jj
As stated before, not exactly needed that much on a standard car and when undertaking the converision is expected to be because of better suspension/engine etc so running lame offsets are always used.

Quote:
Then today is your lucky day, go play the lotto

I actually like this brake set-up and I'm sure other 13" wheels will clear. I just wanted others to be aware that some 13's might not. You should check.

FWIW... I think my wheels have about a +12mm offset and about 100mm backspacing.

standard b310 13" steelies dont fit. Gutted becoz they were going to be the spray the car on bikies

Bolt them on back to front

geez dodgeman, id hate to see how long your post would be showing how expensive it would apparently be to built my car