anyone got a good pic of their intercooler setups, I wish to cut the least of anything out of the front end and have it legal, I dunno if they let you cut holes the the front panels beside the radiator legally. Where have you guys all plumbed the pipes through?, I take it a 450x300 would fit? if not correct me.

mine is a 450x300x76, fits well...

Attach file:

---

  PB200185.jpg (29.84 KB)

here
check out build threds
450x250x70

Attach file:

---

  100_1460.JPG (180.49 KB)

I don't know what size it is but I could measure it up if need be...

http://datsun1200.com/modules/newbb/viewtopic.php?topic_id=42547&forum=1&post_id=282127#forumpost282127

Search and you will find...

To fit a 450 x 300 x 76mm neatly behind the grille
you will defintely need to do some trimming of the
radiator support panel. Most I have seen have also
required some minor trimming of the front apron panel
as well.

I am trying to avoid the trimming of the front apron panel
and have been looking for a slightly thinner cooler.


He Tommoz where did you get your cooler from and how
much was it. Also does it have 3inch of 2.5 inlet/outlets??

600 x 300 x 75. - Was a hybrib cooler, just mounted it up side down.

Attach file:

---

  240.jpg (54.13 KB)

got cooler from ebay, 2.5 inch inlet/outlet,cut and rewelded in/out
made it fit alot better
check my project thred

Attach file:

---

  100_1369.JPG (167.54 KB)

Done mine a bit differently, but probally alot more work.

Check out my build thread

wow thanks for all the replies.