for sure, will pull it tomorrow after work and post the pic :)

One comfort I'd like would be an intermittent setting like the new ones, it's annoying turning the switch on and off every 10 seconds in the light stuff

Hmmm i may experiment all this soon too. I hate storm season! wipers are to slow to see anything so always got to pull over and wait.

i can buy a kit from jcar to have intermittent setting

Lowmion where abouts are you? I really like your setup very clean and industrial looking.
I dont want to put you out but if you are willing to take a fiver on top of the price of
the T section, You could get a group buy happening. Its the best setup Ive seen in years.

d i have one fs

u can buy copper t's like 2x 1.5inch and 1x .5inch from pluming suplies

Ive been to plumbing supplies in the past for such a fitting and also
for the one in the back of the heads for the heater but never found
the right size T one. Will have to go looking to other plumbing places
but its such a hassle going to so many of them and turning up silch.

the only other option is SS but not as good as lowmion setup I reckon
as its straight tube reduce T 31mm inside diameter and 12 reducer
http://www.geordi.com.au/Products15d.htm

Attach file:

---

  Teereducer.jpg (3.43 KB)

just took mine out and the outer diameter of the T pipe is 27mm inside 22mm
reducer pipe is 15mm outside and inside 13mm.

Called His, benton plumbtec and a few others and only have 25mm x 19mm so far
so really looking forward to seeing what Lowmion has used to solve the most
frustrating thing I find with the heating system on old A series engines.

This is what you could use for a Datsun 1000:




Or for advanced technology maybe something like this:



D is this what you are describing?



or this?

Attach file:

---

  water connector.jpg (6.59 KB)