I could redo it. The hardest part was the cutting to fit it in the dash. The gauges could be a little closer together.

Well.

1. Fuel Pressure
2. Air Fuel Ratio
3. Trans. Temp
4. Voltage
5. Fuel Level
6. Engine coolant Temp
7. Oil Pressure

I put the ones in the right because I'm use to seeing them on the right.
I may take D's advice and move them in a little closer.

Scrapping the last panel and already started another one. Bring gauges in closer and all within view. Will post another photo.

So I made a new panel. One that I can see all the gauges through the steering wheel so now all gauges are on the panel except for my tach which will remain on top of the dash. Still working on wiring. Total Chaos.
I mounted bolts on the clutch of my supercharger so now its fixed. If it was ever slipping, it wont slip now.
And lastly, I scored on a nitrous fill station. $200 for the tank and pump. I bought it from the guy that is building my adaptor plate for my Powerglide transmission. He's been busy but says hopefully later this week. He's also going to build me a bigger crank pulley for my supercharger. Will go from 6 inches to 7. So at 7000 rpms, that will max out the rated rpms on the supercharger at 14,000. Hopefully my boost will increase to 10 psi.
For now Ill keep plugging away on the wiring. Almost done. Will be nice and neat soon.

Attach file:

---

  IMG_20141206_110234_860.jpg (169.04 KB)


  IMG_20141207_211327_561.jpg (175.69 KB)


  IMG_20141207_211618_080.jpg (152.71 KB)


  IMG_20141207_211227_341.jpg (141.43 KB)

Did you put your hands on the wheel to make sure they don't obstruct your view of the guages? I forgot that With my tachometer last time

They all look pretty good.
No work on it today. I had other stuff going on.
Still need to finish wiring. Getting close.

Looking great, excellent effort, heaps of visibility

Couple of shots of the GM Powerglide Transmission adaptor plate on the mill and the KA bell housing.
My friend just got around to fabbing it. Its been a busy month.
Finishing up my wiring so gauge cluster should be installed soon just in time to start modifying my trans. tunnel. Looking forward to another finished project.

Attach file:

---

  IMG951828.jpg (187.37 KB)


  IMG951829.jpg (167.56 KB)

Finished and it looks good!
Picking it up tomorrow.

Attach file:

---

  IMG_4564.jpg (153.67 KB)


  IMG_3337.jpg (161.10 KB)

Finished project????!!!!

you will be part of the small group that do!
Cause unlike 99% datto owners including me
I had to make up a quote to realise.....

"You can never finish a Datsun - Xcept on the Finish line"